Forget Masters and Johnson or Dr. Ruth. Where size really matters is shower doors.
With the basin for our new shower glued down just as nice as you please (see “Basin or Mason“), we turned our attention to walls and doors. The walls were going to be covered with 1” glass tiles.
My ever-loving wife, “Jenny Mae” (not her real name), wanted frameless glass doors because they look the best, which they do. It turns out you can get them either “exact fit” or with side pieces that can adjust an inch or so wider or narrower. The side pieces kind of clutter up the clean look so we opted for the exact fit.
Measure twice (OK, about 10 times) and order once
The pressure was on this Math major to measure the door opening precisely. The rough opening was 60″. The tiles are glued on sheets of 1/2″ thick Hardibacker, which is like cement backer board but a whole lot lighter and easier to work with. Two sides make it 1″. Subtract that from 60″ and we should order doors 59″ wide. Done.
The fur starts to fly
The next step is to get the walls ready for the tile. But before you screw the 1/2″ backer board to the studs, the instructions said to put 1/4″ furring strips on the studs to keep the backer board inside the little walls of the shower pan. For those of you animal rights activists, furring strips are strips of wood not whatever else you might be thinking. Continue reading (Door) size matters